3BHB045647R0001 GVC736CE101 代码位于链接文章的末尾附近

　　以类似的方式，3BHB045647R0001 GVC736CE101终端闪烁绿色警报的设置和软件信息可以在以下内容中找到文章(代码位于链接文章的末尾附近)。

OpenPLC联锁定时器标签如图12所示，3BHB045647R0001 GVC736CE101梯形图如图13所示。

根据当前LD，闪光灯仅在SW1处于默认释放状态时工作。联锁定时器的手动控制操作(仅在按下SW1时闪烁)可以通过简单地将Start_Timer位更改为图13中的检查是否关闭XIC指令来建立。

随着软件安装在控制器和基于HMI的LCD显示单元上，将实现全功能视觉报警器。要查看运行中的系统并验证您自己的项目，请查看演示M5堆栈核心单元和ESP32终端装置.

In a similar way, the setting and software information of the 3BHB045647R0001 GVC736CE101 terminal flashing green alarm can be found in the following article (the code is located near the end of the linked article).

The OpenPLC interlocking timer label is shown in Figure 12, and the ladder diagram of 3BHB045647R0001 GVC736CE101 is shown in Figure 13.

According to the current LD, the flash only works when SW1 is in the default release state. The manual control operation of the interlocking timer (flashing only when SW1 is pressed) can be established by simply changing the Start-Timer bit to check whether the XIC command is turned off as shown in Figure 13.

As the software is installed on the controller and HMI based LCD display unit, a fully functional visual alarm will be achieved. To view the running system and verify your own project, please refer to the demonstration of M5 stack core unit and ESP32 terminal device